Engine Build Sheet Template - I have each area of the car broken up into sections, hyperlink where i can and the number of every scanned receipt. I had all the bits and looked at everything else. I kept some parts for use on the new car and the spreadsheet came with it. Anyway, i want to swap a pontiac 400 in it someday and want to know a good budget build to get around 400lb/ft of torque. The heads have been ported but the crank is stock to my knowledge. Build a natuarlly aspirated small block chevy, that will produce 600hp at the flywheel. Engine is rebuilt, unknown milage but very few (under 10,000) from the information i gathered. A close examination of shaver's engine reveals the details. Overbore max.060 crank, any brand, off the shelf. I contacted him and asked him if he would build me a overflow to my dimensions and the way i wanted it built. Picked up from craigslist for 1350.00 after some negotiation. Must be off the shelf no custom built. When i tore into the engine, i could still see the cross hatching on the cylinders so i took it to the machine shop to be cleaned up and installed new bearings, rings and gaskets. It also came with a dyno sheet. Rods, and brand, any length as long as pistons avalible for size.
302 Built And Ran In A Early Bronco.
Picked up from craigslist for 1350.00 after some negotiation. Must be off the shelf no custom built. When i tore into the engine, i could still see the cross hatching on the cylinders so i took it to the machine shop to be cleaned up and installed new bearings, rings and gaskets. The mh build worksheet started out with my previous car which i parted out.
Engine Is Rebuilt, Unknown Milage But Very Few (Under 10,000) From The Information I Gathered.
I had all the bits and looked at everything else. What does it take to make 700 hp from a 10.5:1 compression, pump gas, 427? Build a natuarlly aspirated small block chevy, that will produce 600hp at the flywheel. It also came with a dyno sheet.
The Build Had Less Than 1000 Miles On It From What I Can Tell Before The Previous Owner Wrapped The Rear End Around A Pole.
Overbore max.060 crank, any brand, off the shelf. I was looking at sheck44's '69 camaro build and he had a remote power steering reservoir that was made by a guy in california. I had the engine build sheet but lost it. Thick ss material and a ss screw on cap with o'ring.
I Kept Some Parts For Use On The New Car And The Spreadsheet Came With It.
The engine currently is a very weak 305 with a th350 transmission. I built the custom 4 link (8.8) in the 1988 rx7 as well as some of the engine build in the '88 and the transmissions in both. 6.0 l96, t56, strange 9 inch, ridetech coilovers, wilwood brakes Rods, and brand, any length as long as pistons avalible for size.